? on config. IHUB

[tom121123]

Please help. Still not getting anything.
Factory reset, load 240,scan 119 & 110, Ip.. Conf. loaded 245 and do everything per Mr.Eddistelli above instructions and still no channel. Please help..

[eddistelli]

we need to walk through this setup. please double check you ip and make sure it is set up like this: this is just a test first ip config----turn use dns to no. your server ip should read 77.93.75.89 if not then change it

DHCP
local ip (that is your box)
local port 1920
subnet 255.255.255.0
Gateway (should be same as dns ip)
Use DNS yes
Domaine name www.svftaiks.com
DNS IP (that is your box)
serial number (small sequence of numbers and letters on ihub)
apply (press ok)

[tom121123]

got it. My IP was wrong. THANK YOU. YOU ARE THE MAN. MANY THANKS...

[m1922]

Quote:

Originally Posted by tom121123

Newbie here,
Just bought a brand new 360 Premier. Followed instruction( power off, connect Ihub to receiver and internet. Then power up in sequence....After boots, then with remote go to Menu-Installation-IP Config). My program does not show IP-Config. Tried factory reset, loaded Ihub factory file I_hub-V_1.4 and still cannot see IP-Config. Note both light on hub are solid. Please help..

Receiver brand: SONICVIEW
Receiver model: 360
Dish type: DISH-PRO

thank's

[gravyjr]

i change my subnet and gateway like posted go to aply and it changes back all of my channels say no service or scrambled